frp softener vessel
Links
-
Post time: 18-11-22 -
Paint on the galvanized layer, the binding force between each other and the baking temperature of the paint has a great relationship, after galvanized coating alkyd paint, adhesion is no problem. Galvanized amino paint, paint adhesion is not good. Do two bottom two surface, adhesion is ok, if the two bottom two surface to two bottom three surface, that is, more paint, more baking once, again test adhesion is very poor, poor to the paint from the galvanized layer of pieces torn off.
-
Post time: 09-09-22 -
Wire mesh welding after galvanized is through the end of the welding and then the cold company to make wire mesh wire mesh steel mesh construction mesh floor heating mesh galvanized or hot galvanized. After the first galvanized welding is to change the wire mesh, after the end of welding can see the welding spot; The two processes are different prices are also very different, the cost of the first plating after welding is low, the appearance is smooth, and the cost of the first welding after plating is higher, not easy to rust.
-
When the large roll galvanized wire galvanizing process coating foaming, first check the bath temperature. If the bath temperature is not low, then strengthen the plating before removing oil, prevent the matrix metal in acid corrosion. If you pay attention to these problems, the foaming phenomenon still exists, it should pay attention to the amount and quality of additives, then you can stop adding additives, with high current electrolysis for a period of time, in order to reduce the content of additives, observe whether the foaming phenomenon is improved. If there is still no improvement, it is necessary to check whether the storage period of additives is too long, or whether there are too many impurities in the additives.
- 4. When cleaning the cage, remember not to brush violently, but pay attention to the strength. Otherwise easy to damage the surface of the paint layer.
-
(1) Easy to use, only the mesh surface tile wall, building cement can be used;
-
1. Principle. Because zinc does not change easily in dry air, and in humid air, the surface can form a very dense film of zinc carbonate, which can effectively protect the interior from corrosion. And when the coating is damaged for some reason and the matrix is not too large, the zinc and steel matrix form a micro cell, so that the fastener matrix becomes the cathode and is protected. It is widely used in automobile transportation and other industries, but what is needed is the trivalent chromium passivation layer, zinc nickel alloy plating closed coating, reduce the harmful and toxic layer of hexavalent chromium passivation.
-
In the calculation process of 12*14 specifications of barbed rope, it can not be calculated according to the above calculation formula, because first of all, two specifications of raw materials are used, the thinner the wire diameter, the higher the processing cost. Generally speaking, a kilogram of 12*14 barbed rope can reach about 7.5 meters, and the ratio of warp wire to barbed rope cannot be calculated according to the traditional ratio of 7 to 3. The specific use of how much wire and silk need to go through a series of professional measurement but also increase the loss of raw materials and other factors to calculate. Thorn rope factory will also according to customer needs to calculate the reasonable amount of customer use.
- The management system of the rinsing water after wire pickling should be discharged regularly and regularly, and the rinsing water should be kept clean and low acid value as far as possible. It is more appropriate to control the pH value of 3. The concentration of plating aid should not be too high. The hot plating wire must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is added without reference to the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.
-
Post time: 07-09-22 - Barbed rope manufacturers specializing in galvanized barbed rope, hot dip galvanized barbed rope, blade barbed rope, stainless steel barbed rope, plastic coated barbed rope, positive and negative twisted barbed rope production for ten years.
- 5, according to the wire diameter thickness to adjust zinc dipping time
-
Nestor rolling cage, high-speed railway Nestor rolling cage and railway Nestor rolling cage are all produced, sold and installed in accordance with the technical requirements of the reference drawing of railway line 2012-8001. Nestor rolling cage is a kind of protective equipment emerging in railway in recent years. Nestor rolling cage is connected by Nestor connecting clip on the longitudinal tensile rib fixed on the bracket. The longitudinal tension and the support are connected with the Φ2.5mm cold-drawn galvanized steel wire around 2 laps and then tightened. The support is set in the column and the middle of the span of the protective fence of 3m. The other spans are only set with the upper column, and the support and the protective fence are connected with the bracket hoop. For the protective fence that has been installed with metal mesh, the Nestor roller cage is directly fixed on the transverse sheet and wire of the metal mesh with the cold-drawn galvanized steel wire of 2.5mm or the Nestor connection fastener.
- C, coating uniformity: galvanized layer is basically uniform with copper sulfate solution test etched five times without exposing iron.
-
Post time: 11-05-23 -
The service life of the original galvanized iron welding mesh is very limited. Generally, good iron railings can only be used for about 2 years, and then renovated until the service life, which is not only time-consuming but also has safety risks. After the appearance of zinc-steel railings, the service life has been increased to a great extent in the post-processing. Generally, it can be used for at least 20 years. To improve the service life of zinc steel railings, we first have a brief understanding of the product characteristics of railings. Then from the maintenance aspect, it is necessary to maintain. Maintenance method of electric welding mesh:
- Annealed wire is a kind of soft iron wire made of low carbon steel by cold drawing, heating, constant temperature and heat preservation. The composition of the wire varies according to its use. It contains iron, cobalt, nickel, copper, carbon, zinc, and other elements. The hot metal billet is rolled into 6.5mm thick steel bar, that is, the wire rod, and then it is put into the wire drawing device to draw the wire of different diameter, and gradually reduce the aperture of the drawing disk, cooling, annealing, plating and other processing technology to make a variety of different specifications of the wire.
-
Post time: 12-04-23 -
Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.
- ① The diameter of galvanized iron wire for drawing shall not be less than 4mm, and the diameter of galvanized iron wire for binding shall not be less than 2.6mm.
-
(1) In the painting construction should pay attention to ventilation, moisture-proof, fire prevention. The working environment and painting tools should be kept clean, the pressure of the air pump should be controlled within 0.63MPa, and the safety valve should be checked for failure.
- Of course, the quality of any product is also affected by the implementation of the manufacturer’s norms. If it is the manufacturer of electric welding mesh in production, it does not have a high implementation of the norms, or the procedural norms on the production line have decreased, or there is no higher requirements on the production link.
-
1. Zinc pot operators must stick to their posts
-
1. Electroplating process control
-
The temperature of large roll galvanized wire should be controlled at 30 to 50℃ during electroplating. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used. Continuous production does not need heating, but needs cooling. Cooling can be in the groove side row thin wall plastic pipe, through the flow of tap water cooling, can also be used as a titanium pipe temperature control device.
- The screen is made into a box-like container, with stone filled with cages, can be used to protect and support seawall, hillside, road and bridge, reservoir and other civil engineering, flood control and flood resistance is a good material.
-
If it is not packaged, then a car of blade thorn rope can not be loaded with many pieces, and it is also relatively occupied and easy to lose in the transportation process. The number of the packed blade thorn rope is 50 bundles, and the volume is reduced after hydraulic compression so that it is more convenient to load and unload, and the forklift can easily load and unload. Under normal circumstances, when exporting, the blade thorn rope will be packaged and sold, so that the volume occupied in the container is relatively small, which can be easily placed and will not occupy much place.
-
The material of small hexagonal mesh is the same as that of other hexagonal mesh, which is generally made of low carbon steel wire, stainless steel wire and galvanized steel wire as raw materials by the hexagonal mesh machine.
- In addition, hot-dip galvanized wire also needs to pay attention to maintenance and maintenance during use. Although it has good corrosion resistance, the zinc-iron alloy protective layer of hot-dip galvanized wire will gradually wear out after a long time of use. Therefore, regular inspection and maintenance of the surface of hot-dip galvanized wire, such as recoating or anti-corrosion treatment, helps to extend its service life.
- 4, barbed wire protective net and culvert intersection, such as the ditch is narrow, barbed wire barbed wire protective net can be directly crossed, the ditch is wide, barbed wire barbed wire protective net is difficult to cross, can take the treatment method of bridge, channel.
-
Large roll galvanized wire can be divided into hot-dip galvanized wire and cold galvanized wire, the difference between the two lies in the way of zinc and the amount of zinc. Hot dip galvanizing is to soak steel wire in melted zinc liquid, hot dip galvanizing zinc fast, zinc layer thick rust prevention performance is very good, but the zinc is not uniform, and the surface is dark, the life of hot dip galvanizing can reach 20 years.
- Mainly suitable for flat welding.
- The new weaving machine can weave 3.5m wide, 5cm narrow, can be customized according to customer requirements.
- And the role of wire mesh in the exterior wall plastering if from an Angle of anti-falling method, the effect of anti-cracking is relatively small, because of the azimuth problem; And about the external insulation system is used in the brick veneer, as for the role should also be anti-drop followed by anti-cracking, so we should choose the grid 10×10×0.6, these are some experience selection, the conversion of the grid comes from the national standards of steel wire mesh, the selection of steel content of the grade conversion.
-
Post time: 31-10-22 - wire mesh fence sizes
- 3d welded wire fence
- 4 ft black chain link fence cost
- 2 inch welded wire mesh
- 2 inch x 2 inch wire mesh
- 72 x 100 welded wire fence
- 16 gauge galvanized wire fencing
- brc weld mesh
- plastic coated tie wire
- pvc gi wire