ZJ Composites frp trench drain

Our country industry chooses the low carbon steel with good quality as raw material, and then produces the quality galvanized iron wire by drawing, galvanizing and other processes. Now the production technology of galvanized iron wire products can be divided into hot plating and electroplating two kinds of methods. No matter which one is chosen, it should be carried out in accordance with the corresponding operating specifications, so as to better ensure the production of good products. For key and important parts with tensile strength greater than 1034mpa before plating, the stress should be released at 200±10℃ for more than 1 hour and 140±10℃ before plating.

Thus, when zinc is sufficient in a solid melt, the two atoms of zinc and iron disperse with each other. The zinc atoms in the iron matrix are moved into the lattice of the matrix, and the iron elements are gradually formed into alloys. The zinc composition of iron and intermetallic compound FeZn13 in molten zinc solution and the bottom of hot galvanized sheet can be used as zinc slag. The pure zinc layer composed of zinc leaching solution is hexagonal crystal.

Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.

Some welding methods of galvanized steel mesh will reduce the quality of low carbon steel welded joints, such as electroslag welding. Because the line energy is high, the coarse grains in the heat affected zone of welding will become very coarse, leading to a severe reduction in impact toughness. After welding, it is necessary to normalize with refined grains to improve impact toughness.

The common barbed rope produced by the manufacturer is the 14*14 type of barbed rope product. Since the warp wire used is the same as the wire diameter of the barbed rope, it is easier to calculate the length and weight. Usually each kilogram of barbed rope can reach about 10 meters of service length. The length of each kilogram of raw material is about 35 meters. Since 35 meters of raw material wire diameter can produce 10 lengths of barbed rope cost.

(6) Save transportation costs. It can be reduced into small rolls, and involved in moisture-proof paper packaging, occupying little space.

Steel mesh factory – improve the crack resistance and shock resistance of concrete. Because of the characteristics of steel mesh, it has good bonding and anchoring performance with concrete, and the load distribution is uniform, which greatly improves the seismic and crack resistance ability of reinforced concrete structure.

Black iron wire application in the process, the main is through the hot metal billet rolling into six point five mm wire rod, and then put it in the drawing into a line of different diameter, the plant and then gradually narrow drawing plate aperture, cooling and annealing, plating process, such as making a variety of different specifications of the wire, the wire compared with ordinary black iron wire, will be more softer, The softness is also very uniform, the color is consistent, widely used in the construction industry, mining, chemical industry, welding mesh, welding hanger, reprocessing industry, etc.

Post time: 12-10-22

Generally speaking, it is necessary to install thorn rope in pasture, which is simpler and saves time and effort. It is better managed because it is full of spikes that keep livestock away from the barbed fence.

Different from double strands of barbed wire to install directly on the ground, the blade thorn rope is fixed on some affiliate products just again, as was the case according to the common on the wall, often wall width is far lower than the diameter of the blade thorn rope under the premise of no such device is fixed in place, use special stents to prevent blade thorn rope can better protect us.

Post time: 24-02-23

In our daily life, we are certainly familiar with the construction of power grid. Choosing such special barbed rope can improve the safety factor of the entire power grid during construction. In fact, after the construction of the power grid does not need to be energized, the only security measures can play the equipment is these galvanized barbed rope, in the choice of time is certainly to choose some of their own needs, and the quality of the product of reliable materials.

Galvanized iron wire is divided into hot galvanized wire and cold galvanized wire, using low carbon steel wire processing, after drawing molding, pickling rust removal, high temperature annealing, hot galvanized, cooling and other processes. It has good toughness and elasticity, and the amount of zinc can reach 300 grams/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Galvanized iron wire can be cut off in the construction of the tie wire, the length of 20cm, 30cm and 40cm, can be cut off according to requirements.

The policy of wire mesh mesh size, wire, square meter steel content, galvanized amount, etc., to consider the corrosion resistance of wire mesh ability and system safety! Wire mesh galvanized is more fierce than the wire diameter, galvanized is very important, must be hot plating, welding after plating is better than the first plating after welding, as for wire diameter, inductive consideration of site construction and meet the needs of safety.

Post time: 20-09-22

Large roll galvanized wire is processed from high quality low carbon steel wire rod. Each wire rod rolled by continuous rolling mill is not less than 200kg, but 15% of the number of plates in each batch is allowed to be composed of two, of which the weight of each rod is not less than 80kg, and 4% of the number of plates in each batch is allowed, and the mass of its single wire rod is less than 200kg, but not less than 40kg. Each rod rolled by semicontinuous mill shall not be less than 60kg, and each batch shall be allowed to have 5% disk nitrogen. The mass of the rod shall not be less than 60kg, but not less than 30kg.

Open pit coal mine due to poor air quality, a variety of harmful heavy metals are also more, so the corrosion strength of barbed rope products is particularly large, when using galvanized barbed rope must choose hot plating or plastic coated galvanized barbed rope, although the price is slightly higher, but in the long term development is more appropriate. Besides, when the barbed rope is installed near the coal mine, the pile foundation should be fixed to prevent the barbed rope from falling down due to soil erosion, thus losing the protective effect.

Post time: 13-05-22

According to the different requirements of the industry, different weights of alloy ingots are put in the smelting furnace according to the standard, such as weaving, Ming, paper, lang, silicon, etc., and the data out of this smelting is called gold ore iron. Iron has gray iron, white iron and the above-mentioned gold, they have different characteristics, so in the industry according to their different characteristics to transport and selection. For example, in gray iron, its carbon exists in iron ore in graphite condition, the crack is often gray, soft and strong, simple filtering, suitable for casting.

For mountainous or hilly areas where the ground is more undulating set up stakes. You need to set a stake at the beginning and the end, and then determine the position. In the middle of the ups and downs, to increase the stakes according to the complexity of the ups and downs of the terrain, we need to be able to see 3 stakes at the same time, so that the installation is. It’s a straight line.

3. The front and back twist barbed wire has a beautiful appearance

In order to adapt to the living habits of different birds, ornamental cages can be roughly divided into two types of bird cages, namely cereal and insectivorous cages. Cereal bird cage with canary cage, yellow bird cage, wenbird cage, bird cage, hydrangea cage, insect-eating bird cage with thrush cage, chin cage, myna cage and so on.

Hook net raw materials are basically low carbon steel wire, stainless steel wire and aluminum alloy silk woven, and what are the characteristics and use of these raw materials? Low carbon steel wire is actually the wire we usually use, plasticity is good, good patience, pull is very good.

Post time: 28-03-23

The blade gill net has 3-7 buckles every 2 turns, and it is a circle card. After being opened, it forms a spiral shape. When stretching, you must take protective gloves to prevent scratches. When opening, only one side of the gill net needs to be fixed, and then the gill net needs to be opened in the opposite direction. Pay attention to the spacing of the holes should not be too large, otherwise it will affect the aesthetic effect. As long as the time to slowly return to the line, simple operation, convenient construction.